|
|||||
|
|
Step #1: Pull the bolt pin upwards and slide the bolt out the
back of your Cyborg. |
||||
|
|
Step #2: Using a 5/64
allen key, unscrew the eye covers (counter-clockwise) and place to the side. |
||||
|
|
Step #3: Gently wiggle
the eyes free of their sockets. |
||||
|
|
Step #4: Remove the
ball-detents by unscrewing them counter-clockwise. |
||||
|
|
Step #5: Run a barrel
swab through the breech. You may want to repeat this several times. |
||||
|
|
Step #6: Using a clean
piece of paper towel, wipe any old paint off the eyes and ball detents. Wrap
a piece of paper towel around your finger and insert it into the feedneck –
wipe the inside of the feedneck and ensure no old paint or debris is
present. Using a q-tip or scrunched piece of paper towel, clean the ball
detent and eye sockets. |
||||
|
|
Step #7: Using a piece
of paper towel, wipe the bolt clean and ensure it is free of old paint and
debris. Make sure there is no grit lodged in the o-ring groves. If you have
a Sonic or 06 bolt, apply a drop
of Triflow or a light gun oil to each o-ring. |
||||
|
|
Step #8: It’s now time
to reassemble your Cyborg. First, reinsert the eyes into their respective
eye sockets. Screw the ball detents back in counter-clockwise -- do not
screw them in too tight. Hand tight is sufficient. Using a 5/64 allen key, replace the eye cover
screw and tighten by screwing clockwise. Slide the bolt back in and depress the bolt pin into the ram. |
||||
|
All page contents Copyright ©
BorgFocus.com |