Borg Focus | Cyborg Tech Library


Home | Maintenance | Electronics | Trigger | Troubleshooting | Links | Contact


LPR MAINTENANCE - 06 Cyborg

Recommended Frequency: approximately every 8,000 pressurized cycles.



Instructions:
(click images for an enlarged view)
 

    
   
 
Step #1: Grip the bottom portion of the LPR and unscrew it counter-clockwise to remove it from the body.
 
    

 		 Step #2: Tap the exposed hole on your palm to shake out the poppet, spring and LPR spacer.
 

 		 Step #3: Wipe the poppet clean and apply a drop of light gun oil or Triflow. If you have a delrin 07 valve poppet, then apply a thin coat of dow 33 instead.

 

 		 Step #4: Hold your Cyborg vertically and drop the poppet back into the valve. Follow this by dropping the spring, and then the LPR spacer in that order.

If the poppet does not land in the valve initially, or the spring doesn’t sit ontop of the poppet, shaking the body gently should align them correctly. If not, tip them back out and try again.
 

 		 Step #5: Unscrew the top portion of the LPR counter-clockwise.

Be careful not to lose the small parts when unscrewing this.
 

 		 Step #6: Using a pair of needle nose pliers, remove the LPR piston.

 

 		 Step #7: Remove all old lube and debris from the LPR piston housing using a q-tip or scrunched piece of paper towel.
 

 		 Step #8: Wipe all the old lube and debris off the LPR piston using a paper towel.


 

 		 Step #9: Apply a thin coat of lube, about half a pea amount, to the LPR piston o-rings.
 

 		 Step #10: Cut the cotton head off a q-tip. Apply a small amount of lube to the end of the shaft (quarter of a pea-size).

Use the lubed q-tip shaft to apply a thin layer of lubricant to the inside of the LPR piston housing.
 

 		 Step #11: Replace the LPR piston into the piston housing. Align the small spring onto the piston, and place the silver bit ontop.
 

 		 Step #12: Lightly lube the threads of the LPR housing cap, and then screw it clockwise into the LPR housing.

 

Step #13: Screw the LPR back into your Cyborg’s body. This concludes LPR maintenance.

Hold the Cyborg vertically while screwing this back together so that the internal parts line up correctly.
 
       
 

All page contents Copyright © BorgFocus.com
This website is not affiliated with MacDev. The Cyborg is a trademark of MacDev.