Sevtec Surveyor
Build methods, errors and fixes....
|
Over all width was
less than ¼” over size. |
Work table extended to support front panels. |
|
Another neat joint. |
Panels H8a and H8b
in place. The bricks keep
them still in the breeze. |
|
I always wondered
what it was like on the other side!!
|
Again reference measurements came of the top of the beam where the G clamp is. |
|
Flipped and all
seams glassed for the final time.
|
This shows where I
cut the coaming thru about 1 ½”
deep, minor error but it made an easy holding slot for it.
|
|
Extra glassing on
joints as per drawings instructions. |
A small batch of
matt appeared to be a little thin , so I added 4” wide cloth over |
Go directly to page…..
11, 12, 13, 14, 15, 16, 17, 18, 19, 20
Page 5 of 12